Ettercap: Difference between revisions
From charlesreid1
(Created page with "This page primarily covers how to use Ettercap to build a bridge between two network devices that can be sniffed. =Setup= ==Software== Install bridge utilities, allowing yo...") |
(→Setup) |
||
| Line 1: | Line 1: | ||
This page primarily covers how to use Ettercap to build a bridge between two network devices that can be sniffed. | This page primarily covers how to use Ettercap to build a bridge between two network devices that can be sniffed. | ||
= | =Build Bridge= | ||
==Software== | ==Software== | ||
Revision as of 08:15, 23 August 2015
This page primarily covers how to use Ettercap to build a bridge between two network devices that can be sniffed.
Build Bridge
Software
Install bridge utilities, allowing you to bridge network devices:
$ apt-get install bridge-utils
Preparing Network Devices
Both network devices need to be configured as open IP addresses, by setting them to 0.0.0.0.
Assuming the two devices are a wireless card wlan0 and an ethernet connection eth0, this would look like:
$ ifconfig eth0 0.0.0.0 up $ ifconfig wlan0 0.0.0.0 up
Bridge Network Devices
We'll add a bridge, and add endpoints to the bridge.
$ brctl addbr lucifer $ brctl addif lucifer eth0 $ brctl addif lucifer wlan0
Finally, we can raise the bridge:
$ ifconfig lucifer up