Widy/Redux

Widy redux - returning to the project after a few months away from it.

Getting Back Up And Running

I used Barrier Breaker version of OpenWRT, but I don't recall which firmware platform I picked. I could probably refer to the documentation for the TP-Link router (TP-Link Portable 3G/4G Wireless N Router, TL-MR3040) on the OpenWRT wiki or elsewhere.

To boot up the Widy device:

1. Make sure the Widy is off.

2. Set the Widy into 3G/4G mode.

3. Connect the Widy ethernet port to your computer's ethernet port.

4. Turn the Widy on.

If you monitor your ethernet port, using your operating system's network utility, you should see the Widy device show up at 192.168.1.1. If it shows up at some other IP address, turn the Widy off, ensure it is on 3G/4G mode, and turn it back on.

Once the Widy has turned on, you can ssh to it via ssh root@192.168.1.1, or alternatively you can use the LuCI web interface by going to 192.168.1.1 in a browser. Both use the same root username/password. When you first install OpenWRT, the username is root, there is no password, and you are prompted to set the root password.

The Software

Let's do a quick survey of the software on the Widy.

Programs

OpenWRT Packages

The following programs are installed through the OpenWRT package manager (can be used via the web interface or via the command line). The interesting ones are:

• aircrack/airdecap/airdecloak
• ettercap
• git
• kismet
• lua
• macchanger
• nmap
• packetforge
• python
• reaver
• ruby
• scapy
• snort
• wget
• iptables/iw
• luci
• uhttpd

Configuration

Nothing was configured to run at boot. Need to look at the OpenWRT wiki to determine how to do that.

Link: https://wiki.openwrt.org/doc/techref/preinit_mount

That way, when the Widy boots, the router can right away be running, listening, monitoring, and trying to connect to the home base.